VENTS VNV-1A 80

• Exhaust ventilation of high-rise residential and non-residential premises.
• Suitable for premises with mono-pipe ventilation system.
• Mounting in kitchens, bathrooms, toilets, storerooms and other household rooms.

• Installed into the plastic or fireproof casing.
• For periodic or continuous operation.

• The front panel is made of high quality and durable ABS plastic.
• Equipped with a polyether filter for motor and impeller protection against dust and dirt penetration (G4 filter class ).
• The turnable front panel conceals possible inaccuracies of the fan casing installation.

• Fastened to the casing by means of latches and requires no tools.
• The impeller design provides increase of the fan efficiency and the motor service life.

• Energy-efficient 2-speed motor with minimum energy demand.
• Independent maintenance of pressure and air flow rate in the duct.

• Ball bearings increase the motor service life.
• For precise characteristics, low noise level and safe operation each turbine is dynamically balanced while assembly.

VNV-1A(E) 80 T— the fan is equipped with a timer.
VNV-1A(E) 80 TR— the fan is equipped with an adjustable timer.

VNV-1A(E) 80 I — the fan is equipped with an interval switch.
VNV-1A(E) 80 H — the fan is equipped with a humidity sensor.

• Speed switching with the external manual switch. P3-1-300 switch for the three speed fan models and P2-1-300 for the two speed fan models. The speed switches are not included into the delivery set and are available upon order.

The grille fixation to the fan while mounting provides regulation of tne front panel

rotation angle with respect to the casing to conceal possible mounting inaccuracies.

• The fan casing is mounted during construction works and connected to the main ventilation shaft.
• Electric wiring for connection of the VNV-1 80 ventilation unit is led out through a special hole in the casing.
• The front panel is covered with the protective cardboard plate supplied with the unit to avoid damages or contamination during finishing works in the room.
• After finishing the works the protective cardboard plate is removed and the VNV-1 80 ventilation unit is installed into the casing and connected to the wiring.